1. It may improve the efficiency of heat insulation.

2. Endurance : It may produce cool air rapidly; no consumption material; long tool life; low cost; endurable for usage

3. Lubricator : Spiral tube cooler with lubricator may improve the roughness of work piece then increase the fineness
　　　　 of surface; it may reach superior solution through cool air plus oil mist, and prolong tool life and working period.

4, Environmental protection : No electric power and coolant needed; safe, clean, and no pollution. 

5. Temperature of cool air : With multi-layers of thermal tube which may decrease the influence of surrounding
　　　　　　　　　　　　temperature to cool air.

6. Easy to operate : Easy to use, it may produce very cool air through the driving of air compressor

                                  (recommended power: above 5HP)Any person may use it easily without training.

7. Easy to adjust : There is a valve at the entry which may avoid oily and you don’t need to set the volume of oil mist

                               again next time, you  may adjust and select cool air or cool air plus oil mist easily.  

8. Temperature control separately: For divided series only.  It may cut off heat into proper place and keep the work

                                                           room in a constant temperature.

9. Application : Apply for electronic and 3D mold engraving industries, cutting PCB, plastic, acrylic, huge metal, woodwork

                         , Cu, Al, cast iron, etc., also good at nano-grade-machinery working.  It may decrease the working
　　　　　　　temperatureand shake and promote the working quality.

Product Efficiency

   Extremely cool air may decrease the temperature of cutters, avoid temperature of cutter too high which will become sinter then it will cause “cutter broken” and “damage on the surface of work piece.”  The cool air may balance the temp. of cutting part, avoid deforming of work piece, and increase work accuracy.  After testing, compared with general air, the extremely cool air may weaken the sudden friction obstruction, prolong cutter life, and make the surface of work piece more smooth.  As everybody knows, oil mist may lubricate the cutting part, and it may protect cutters to make the surface flatter.  Hence, extremely cool air plus oil mist make your work perfect.